Hand-Woven Spiderweb Halloween Greeting Cards

by Crafty Lumberjacks

Craft a Spooky Handmade Card with Embroidery Floss and a Vintage Touch!

September is National Sewing Month, but who says you need to sew to celebrate? Get in the crafty spirit with this no-sew Halloween greeting card DIY that’s both spooky and stylish. Learn how to create delicate spider webs using embroidery floss—no stitching required!

We’ll also show you how to give your project an aged, vintage look with a deckled edge paper technique. Whether you’re decorating or sending Halloween cheer, this handmade card is frightfully fun to make.

👉 Bonus: Full step-by-step video tutorial included in this post!


🧵 Supplies You’ll Need

All items can be found at Michaels or your favorite craft store.


✂️ How to Make a No-Sew Spider Web Greeting Card

Step 1: Cut and Prepare the Paper

  • Cut watercolor paper to 6×6 inches using your trim and score board.
  • Score a ½-inch border on each side.
  • To create a deckled edge, press down with your metal ruler along the scored line. Start at one corner and slowly tear the paper along the edge. Repeat for all four sides until you have a 5×5-inch square with rough, aged edges.

Step 2: Create the Spider Web Spokes

  • Place your paper on the cutting mat.
  • Use a thumb tack to poke 8 holes around the square. Start from one corner, go directly across, then rotate and repeat to form an “X” and a “+”.
  • Thread a needle with black embroidery floss.
  • Start from the back, push the needle through a hole, go across, and pull tight.
  • Tape the end to the back. Continue crisscrossing until all 8 lines are connected like a starburst.
  • Tie the center of the spokes together using three strands of embroidery floss.

Step 3: Weave the Spider Web

  • Split your floss into three strands.
  • Tie the thread at the outer edge of one spoke.
  • Begin weaving: Go under, around, then back under each spoke, pulling tight as you move inward in a circular pattern.
  • Add a small dab of glue the areas where you weave on the spoke to help keep things in place as you go.
  • Continue weaving until you reach the center.

💡 Tip: Don’t stress about perfection! Uneven lines and asymmetry make your web look creepier. The messier, the better!


🕷️ Assemble Your Halloween Card

Step 4: Make the Card Base

  • Cut a 12×12 black cardstock sheet in half.
  • Score and fold it to create a 6×6-inch card.

Step 5: Put it Together

  • Glue your finished 5×5-inch spider web square to the front center of the card.
  • For the inside, add another deckled-edge 5×5-inch watercolor square for writing your message.

Step 6: Add Final Touches

  • Glue a plastic spider onto the front of the card for extra spookiness.
  • Write a fun Halloween message like “Hang in there!” or “Creep it Real!” or keep it classic like we did!

📽️ Watch the Full Tutorial Video

See every step in action and get more creepy-cute card inspiration from the full tutorial!

CLICK HERE!


👻 Wrapping It Up

This DIY no-sew Halloween card is a creative way to celebrate National Sewing Month—no stitching required! With textured edges and hauntingly beautiful spider webs, it’s a handmade touch your friends and family will love.

Pin it for later, share it with your crafty friends, and don’t forget to tag your creations on social media!

2 comments

EJ September 23, 2025 - 8:00 pm

OMGoodness! I love this. Thank you for sharing such great ideas.

Reply
Crafty Lumberjacks September 25, 2025 - 4:18 pm

You’re so welcome!! Happy Haunting!

Reply

Leave a Comment

We think you'll like these too

This website uses cookies to improve your experience. We'll assume you're okay with this, but you can opt-out if you wish. Accept